Kit de presión ITV

Kit de pressão ITV "T" 22 / 16-150 Ver maior

Kit de pressão ITV "T" 22 / 16-150

06019002

Kit de acessórios para tomadas de pressão na ITV com buchas de segmento 22 / 150 e encaixe no segmento de "T" 16 / 150

Mais detalhes

EM ESTOQUE

32,67 € com IVA


27,00 € sem IVA

Manufacturer
Cofan
Cofan

Mais informação

Kit of fittings for pressure on ITV with thread 22/150 bushings and "T" fitting thread 16/150

new testing of brakes on ITV

from the 01/01/2012, according to the EU directive 2010/48, all transport European vehicles, both people and goods, whose MMA exceeds 3.5 t will be subjected to a new and more comprehensive testing of brakes. There are two methods to perform these tests.
1. with load: is calculated directly the effectiveness of braking respect to the MMA.
2. no load: braking action is evaluated by extrapolation, using pressure sensors.

what vehicles should go with loads to the ITV?

Vehicles with MMA < 10 t
to have these in hydraulic or pneumatic braking system, not may be submitted to extrapolation. Therefore these vehicles must go with the maximum possible load, at least 2/3 of its capacity.
what vehicles might go without charge to the ITV?

Vehicles with MMA > 10 t
if these have of circuit purely pneumatic is can apply those methods of extrapolation (is necessary that the carrier has placed previously tomas of pressure in your vehicle). Otherwise, the vehicle should be inspected with sufficient load to achieve the required efficiency, or which would mean more inspection and waiting time.

Others vehicles
in them cases of vehicles in which the load can result annoying or dangerous for them workers and users of a center of inspection (transportation of materials dangerous, transport of animals, collected of wastes, etc.) and vehicles of transport collective of people, the load not may be it own for which is intended the vehicle (is necessary that the carrier has placed previously tomas of pressure in your vehicle).

Before go to the ITV
if the system of brakes of your vehicle is fully pneumatic is you can apply the method of extrapolation. For this, go to review with them tomas of pressure for each shaft installed in the side left, so are accessible and operational. This installation not be considered reform.

What should make the carrier
if the simulation of the load is performed starting from them pressures in them pots (through the method of extrapolation), is necessary that the carrier has placed previously tomas of pressure in the side left of the vehicle. This installation is not reform.